Solid Parquet Floor
River sand must be used in the screed of the floor where the solid parquet will be laid. Because sea sand retains moisture for a very long time due to the salt in its structure. This negatively affects dry parquet. It is also mandatory that the screed is glazed with a steel trowel. If cement powder is not sprinkled on it, the screed may spall. The moisture content in wooden parquet should be at world standards (8-10 percent). If the screed has just been poured, it is necessary to wait two months before laying the parquet. The two-month period is valid between April and October, when the weather is hot. This period is also suitable for the building whose heating is on. However, if the heater is not lit, it is appropriate to leave the parquet flooring at the end of the winter. Before laying the floor should be cleaned very well. There should never be any lime or mortar left. If the mortar has been mixed on the dried screed for any reason, parquet should never be laid before waiting for the moisture created in the screed to dry completely (this period is 1 month). The glue suitable for the described screed should be pulled to an area of one square meter with a comb sent by the company and the flooring should be made immediately. If the screed does not meet the mandatory requirements and is rough with a wooden trowel, it should be laid on the concrete floor after mixing the scraper powder with a special glue, obtaining a viscous paste and obtaining a thin layer. 2-3 days after a thin layer is obtained by drawing with a straightedge, the glue should be applied to the completely hardened floor in the same way with a comb and then the parquet flooring should be started. In another system, paving bitumen can be made for isolation between concrete and parquet. After this bitumen dries and hardens a little, it can be installed while it is hot. As the laying process of solid and ties is progressing, it is wiped with this sponge every half meter so that the surface of the parquets is moistened by wetting the sponge and squeezing it thoroughly. After the flooring is finished, a thin layer of dry sawdust should be laid on the parquet and the glue should be dehumidified, which will ensure that the parquet adheres as a tarn. Before starting to lay the parquets, all windows must be installed, paint-whitewash and wallpaper work must be finished. Most importantly, it should be checked whether the heater and pipes are healthy. Use should be avoided for 4 days after the final polish has been applied.
Laminate Flooring
In order to use your parquets for a long time, the smoothness and stability of the floor is very important. It is very important that the floor screed does not cause sand and is not crushed by impact. If these problems are present in your screed, it is necessary to re-screed. Otherwise, there will be cracks due to sandblasting and there will be stretches due to the slope. These are very uncomfortable situations. Therefore, it is useful to check it before laying.
It is an important factor in floor curvatures and pits in flooring. If not corrected, laminates may break from lock places over time. The mattress that is laid under 1-2 mm can eliminate these collapses to some extent, but it is necessary to make corrections for more.
The most practical solution to obtain a solid and smooth wooden parquet flooring price is a self-leviling screed. It has a structure that dries quickly (about 1 day) and can be easily smoothed (self-leveling). Maybe not a job you can do yourself (a master’s help required) but it is the fastest solution.
Flooring Systems 